Zanussi EC 31 Provozní pokyny stáhnout pdf (Strana 19)

With regard to the protection against overheating

of surrounding furniture surfaces this appliance

corresponds to type Y. This appliance or thebuilt--

in cupboard for the appliance respectively may be

located with therear wall andoneside walltowha-

tever high walls or furniture respectively and with

the other side to another appliance or furniture of

the same height as this appliance.

Hob installation

D Cut out the worktop with the cut--out size as sta-

ted. The toleranced sizes must not be exceeded..

Saw exactly at the marking line. Recommenda-

tion: Mark the cut--out with a steel needle.Cover--

glue the line in order to avoid splintering of the

coating when cutting.

D Clean the worktop in the cut--out section

D With tiled worktops the grooves within the contact

area of the cooking area must completely be filled

up with groove material.

D Then fasten the catch springs with screws in the

cut--out at the marked position. The distortion of

the springs serves as a stop on the worktop.

D With natural, artificial stone, or ceramic plates the

springs can be glued in with special adhesive

(synthetic resin, two--component adhesive, etc.)

D The cooking area is entered from the top into the

cut--out section, centered and firmly pressed on

until the springs will catch.

D Check the seal in the supporting frame for perfect

seating and gapless support. Please do not apply

further silicone sealing matter as this will compli-

cate the removal of the hob if servicing is neces-

sary.

sealing

frame

ceramic glass plate

snap--in clamp

worktop

1 2 ... 14 15 16 17 18 19 20 21 22 23

Žádné komentáře

Zanussi EC 31 Provozní pokyny Strana 19