Zanussi ZLB161X Uživatelský manuál stáhnout pdf (Strana 14)

• Turn the pipe to the 1/2“ gas supply

ramp.

b) Connection with rigid metallic pipe

(soft copper, minimum diameter: 8

mm):

• Use a male/female adapter (not

supplied) to install the nut and the

olive on the gas supply ramp.

• Put the pipe into the gas supply

ramp.

2. Use a 22 mm spanner to tighten the nuts.

Keep the gas supply ramp in correct posi-

tion, do not apply force on the gas supply

circuit.

Warning! Do not use a flame to con-

trol for leaks!

3. Fully move the oven into the built-in cabi-

net. Obey the instructions in the section

“Building-in the Appliance“.

4. Seal the connection correctly. Use a leak

detection to control it.

Warning! Do not squeeze the gas supply

ramp and the pipe when you move the

oven into the built-in cabinet.

Warning: This appliance does not operate

with the gas settings as they are. Before

gas connection, it is important to adjust

the injector(s) to the type of gas used. Re-

fer to the instructions in section “Adjust-

ment to different types of gas“.

Adjustment to different types of gas

Warning! Let only an authorized person

do the adjustment to different types of gas.

This appliance is for operation with natural

gas.

With the correct injectors, you can also operate

it with liquid gas.

The gas rate is adjusted to suit.

Replacing the gas oven burner injector:

1. Remove the bottom plate of the oven cavity

(A) to get access to the gas oven burner

(B).

2. Release the two screws (C), which keep

the gas oven burner in position.

3. Carefully move the gas oven burner off the

injector support (D).

Slowly move it to the left side. Make sure

that the gas oven burner bush stays on the

burner mouthpiece. Do not apply force to

the wire of the spark plug connector (E)

and to the thermocouple conductor (F).

4. Release the gas burner injector (D) with a

7 mm socket spanner and remove it. Re-

place it with the necessary one (see table

„Gas Oven Burner Data“).

5. Assemble the gas oven burner in opposite

sequence.

6. Replace the gas type sticker near the gas

supply ramp with the one related to the

new gas type (supplied with the injector

kit).

Warning! A primary air adjustment of the

gas oven burner is not necessary.

Minimum level adjustment of the gas

oven burner:

1. Disconnect the mains plug from the mains

socket.

2. Remove the gas oven control knob.

14

www.zanussi.com

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Komentáře k této Příručce

Žádné komentáře