Zanussi ZLB161X Uživatelský manuál stáhnout pdf (Strana 13)

Gas type

Injector

mark

Nominal

gas pow-

er

Nominal gas flow

Reduced

gas pow-

er

By-pass

needle

Nominal

gas pres-

sure

1/100 mm kW m³/h g/h (kW)

(1/100

mm)

(kW)

(mbar)

Liquid gas

(G30 /

G31)

078 2.5 - 182 1.0 52

30 / 30

28 - 30 /

37

Installation

Safety for installation

These installation instructions are for authorized

persons only!

Warning! Let only authorized persons

(gas and electricity) do the installation,

connection and maintenance of the appliance.

If you do not refer to an authorized person, the

guarantee becomes invalid if there is damage.

Follow the correct procedure and the

instructions in this user manual for installation,

operation and maintenance of gas and

electrical appliances.

Warning! Before installation, make sure

that the local supply conditions (the type

of gas and the gas pressure) and the

adjustment of the appliance are compatible.

Warning! The adjustment conditions for

this appliance are located on the label or

rating plate.

Warning! The manufacturer is not

responsible for damages caused by an

installation which does not agree with the

instructions in the manual.

Installation environment:

• This appliance is not connected to a com-

bustion products evacuation device.

• Only install the appliance in a room with suf-

ficient ventilation.

• Keep natural ventilation holes open or install

a cooker hood.

• There must be a 130 cm² minimum opening

in the built-in cabinet.

Gas connection

The gas supply ramp is on the rear side of the

control panel.

Warning! Do not use rubber flexible

pipes!

Warning! Before gas connection

disconnect the mains plug from the

mains socket or switch off the fuse in the

fuse box. Close the primary valve of the

gas supply.

1

2

1

2

3

1

Flexible metallic

pipe

2

Gasket

1

Rigid metallic

pipe

2

Nut

3

Olive

1. Do not fully move the oven into the built-in

cabinet (about 30 cm).

There are two connection modes:

a) Connection with flexible metallic pipe

(maximum length 2 m):

• Put the supplied gasket between

the pipe and the gas supply ramp.

13

www.zanussi.com

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Komentáře k této Příručce

Žádné komentáře