Zanussi EHE642B Uživatelský manuál

EHE 642KochmuldeHobPlaques de cuissonPiano di cottura ÊåñáìéêÞ åóôßáP³yta kuchennaMontage- und GebrauchsanweisungInstallation and Operating Instructio

30Cleaning and Care3 Clean the hob after each use when it is warm to the touch or cold us-ing hot water and washing up liquid. This will avoid spillag

31 What do I do if ...Rectifying MalfunctionsIt is possible that any malfunction has been caused by a m

32INSTALLATION INSTRUCTIONS1 Important! The new appliance may only be installed and connected by a registered specialist.Please observe this instructi

33 1 Safety Instructions for the Installer• A device must be provided in the electrical installation wh

34Regulations, Standards, DirectivesThis appliance meets the following standards:• EN 60 335-1 and EN 60 335-2-6relating to the safety of electrical a

35 Electrical Connection• Connect the cable form with the 21-pole compact connector to its counterpart

37 SERVICEIn the “What to do if …” section a number of malfunctions are listed that you can rectify you

102Montage / Assembly / Montaggio Ïäçãßåò åãêáôÜóôáóçò / Monta¿

103 Ausbau / Removal / Démontage / Smontaggio / áöáéñÝóôå

22Dear customer,Please read these operating instructions carefully.Pay particular attention to the section “Safety information” on the first few pages

23 ContentsOperating Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24Safety

24OPERATING INSTRUCTIONS1 SafetyThe safety aspects of this appliance comply with accepted technical standards and the German Appliance Safety Law. How

25 Safety When CleaningSwitch the appliance off before cleaning. For safety reasons cleaning the applia

26Discription of the hobHob Features Before Using for the First TimeInitial CleaningWipe the hob with a damp cloth and a little washing up liquid.

27 Using the Rings3 Please note the information for switching the rings on and off and for regulating t

28Uses, Tables and TipsPans• The better the pan, the better the results. • You can recognise good pans by their bases. The base should be as thick and

29 ChartsNote:The figures given in the following table are for guidance. The switch setting required fo