Zanussi ZQA12430DA Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Mrazničky Zanussi ZQA12430DA. ZANUSSI ZQA12430DA User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 12
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
EN
User manual
Refrigerator
ZQA12430DA
Zobrazit stránku 0
1 2 3 4 5 6 ... 11 12

Shrnutí obsahu

Strany 1 - ZQA12430DA

ENUser manualRefrigeratorZQA12430DA

Strany 2 - Safety information

Ventilation requirementsThe airflow behind the ap-pliance must be sufficient.5 cmmin. 200cm2min.200cm2Electrical ConnectionCaution! Any electrical wor

Strany 4 - Daily use

www.zanussi.com/shop 211621530-252011

Strany 5 - Helpful hints and tips

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4First use _ _ _ _ _ _ _ _ _ _

Strany 6

2. Make sure that the power plug is not squashed ordamaged by the back of the appliance. A squash-ed or damaged power plug may overheat andcause a fir

Strany 7 - What to do if…

Environment ProtectionThis appliance does not contain gasses which coulddamage the ozone layer, in either its refrigerant cir-cuit or insulation mater

Strany 8 - Replacing the lamp

ThawingDeep-frozen or frozen food, prior to being used, can bethawed in the refrigerator compartment or at room temper-ature, depending on the time av

Strany 9 - Technical data

• the freezing process takes 24 hours. No further food tobe frozen should be added during this period;• only freeze top quality, fresh and thoroughly

Strany 10 - Environmental concerns

Defrosting the freezerA certain amount of frost will always form aroundthe top compartment.Important! Defrost the freezer when the frost layer reaches

Strany 11

Problem Possible cause Solution The lamp is defective. Refer to "Replacing the lamp".The compressor operates contin-ually.The temperature i

Strany 12 - 211621530-252011

1. Remove the screwfrom the lampcover.2. Remove the lampcover (refer to theillustration).3. Replace the usedlamp with a newlamp of the samepower and s

Komentáře k této Příručce

Žádné komentáře