Zanussi ZWS281 Uživatelský manuál

ENUser manualWashing MachineZWS 281ZWS 2101ZWS 2121

Caution! Make surethat no laundry staysbetween the seal and thedoor. There is a risk of wa-ter leakage or damage tothe laundry.Filling the detergent a

Change a functionYou can change only the delay and spin function beforethey operate.Press the related button to set the new value.Set the delay start1

Do this separately from the laundry wash.Maintenance washWith the low temperature programmes it is possible thatsome detergent stays in the drum. Make

2. Put a container be-low the recess of thedrain pump to collectthe water that flowsout.3. Unscrew the filter tolet the water flow out.4. When the con

Frost precautionsIf the appliance is installed in an area where the tempera-ture can be less than 0 °C, remove the remaining waterfrom the inlet hose

Problem Possible cause Possible solution The filter of the drain pump isblocked.Clean the filter of the drain pump. Refer to 'Careand cleaning&a

ServiceRefer to the information supplied with this appliance forguarantee condition and point of contact. The informationto give to the service is on

3. Remove the internal film.4. Open the door and remove all the items from thedrum.5. Put the front piece on the floor behind the appli-ance. Carefull

219. Remove the four bolts with a key. Pull out theplastic spacers. Remove the power supply cableand the drain hose from the hose holders.10. Replace

The inlet hose• Connect the hose to the appliance. Loose the ringnut to set it in the correct position.• Connect the water inlethose to the cold water

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Environment concerns _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3Technical information _ _ _ _

• To a sink spigot.Refer to the illustration. Put the drain hose in thespigot and tighten it with a clip. Make sure that thedrain hose makes a loop to

21

22

23

www.zanussi.com/shop 155219100-A-202011

Water connection• Do not connect the appliance with old hoses alreadyused. Only use new hoses.• Make sure not to cause damage to the water hoses.• Do

Water supply pressure Minimum 0,5 bar (0,05 MPa)Maximum 10 bar (1 MPa)Water supply 1) Cold waterMaximum load Cotton 5 kgSpin speed Maximum 800 rpm (Z

Accessories1 2341 Inlet hoseTo connect the appliance to the cold water tap.2 Large plastic capsTo close the holes on the rear side of the cabinet af-t

Indicator DescriptionSpinning phase indicatorEnd cycle indicatorEasy Iron button 4Press this button to prevent the creases in the fabrics.When you pre

ProgrammeTemperatureType of load and soilWeight of loadProgrammephasesPossiblefunctionsSynthetics60° CSynthetic or mixed fabric items with nor-mal lev

ProgrammeTemperatureType of load and soilWeight of loadProgrammephasesPossiblefunctions To cancel the programme that it operates or to deactivate the

Detergents and additives• Only use detergents and additives specially made forwashing machines.• Do not mix different types of detergents.• To help th