Zanussi ZWO3101 Uživatelský manuál Strana 1

ENUser manualWashing MachineZWO 3101

Detergents and additives• Only use detergents and additives specially made forwashing machines.• Do not mix different types of detergents.• To help th

Caution! Make surethat no laundry staysbetween the seal and thedoor. There is a risk of wa-ter leakage or damage tothe laundry.Filling the detergent a

Change a functionYou can change only the delay and spin function beforethey operate.Press the related button to set the new value.Set the delay start1

Do this separately from the laundry wash.Maintenance washWith the low temperature programmes it is possible thatsome detergent stays in the drum. Make

2. Put a container be-low the recess of thedrain pump to collectthe water that flowsout.3. Unscrew the filter tolet the water flow out.4. When the con

Frost precautionsIf the appliance is installed in an area where the tempera-ture can be less than 0 °C, remove the remaining waterfrom the inlet hose

Problem Possible cause Possible solution The connection of the water inlethose is not correct.Make sure that the connection is correct. The water pr

Problem Possible cause Possible solution Too much laundry load. Decrease the laundry load.After the check, activate the appliance. The programme cont

3. Remove the internal film.4. Open the door and remove all the items from thedrum.5. Put the front piece on the floor behind the appli-ance. Carefull

219. Remove the four bolts with a key. Pull out theplastic spacers. Remove the power supply cableand the drain hose from the hose holders.10. Put the

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Environment concerns _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3Technical information _ _ _ _

The inlet hose• Connect the hose to the appliance. Loose the ringnut to set it in the correct position.• Connect the water inlethose to the cold water

• To a sink spigot.Refer to the illustration. Put the drain hose in thespigot and tighten it with a clip. Make sure that thedrain hose makes a loop to

22

23

www.zanussi.com/shop 155219300-A-352011

Water connection• Do not connect the appliance with old hoses alreadyused. Only use new hoses.• Make sure not to cause damage to the water hoses.• Do

Water supply pressure Minimum 0,5 bar (0,05 MPa)Maximum 10 bar (1 MPa)Water supply 1) Cold waterMaximum load Cotton 3.5 kgSpin speed Maximum 1000 rpm

Product description1 2 34567 128 910111Worktop2Detergent dispenser3Control panel4Door handle5Drain pump6Rating plate7Feet for the appliance level8Wate

Control panel1345 267891Programme knob2Start button 3Display4Easy iron button 5Extra rinse button 6Rinse hold button 7Prewash button 8Spin button 9Del

Extra rinse button 5Press this button to add rinsing phases to a programme.Use this function for persons allergic to detergents and inareas where the

ProgrammeTemperatureType of load and soilWeight of loadProgrammephasesPossiblefunctionsSynthetics60° CSynthetic or mixed fabric items with nor-mal lev

ProgrammeTemperatureType of load and soilWeight of loadProgrammephasesPossiblefunctions To cancel the programme that it operates or to deactivate the