Zanussi ZGG649ICY Uživatelský manuál

2INSTRUCTION BOOKLETGAS HOBZGG 649

11Building In3020 min60abFO 1013Building over a cupboard or drawerIf the hob is to be installed above a cupboard ordrawer it will be necessary to fit

12a) Sealing gasketBefore fitting the hob into the cut out, an adhesiveseal must be fitted to the underside outside edge (Fig.3) of the hob. It is ess

13Electrical connectionsAny electrical work required to install thisappliance should be carried out by aqualified electrician or competent person,in a

14CommissioningWhen the hob has been fully installed it will benecessary to check the minimum flame setting. To dothis, follow the procedure below.- T

15ServicingA: Removal Of Hob Top1. Remove the panstands and each burner cap andcrown.2. Lift the hob from off the working top.3. Remove the two self t

3Important Safety InformationYou MUST read these warnings carefully before installing or using theappliance.Installation● This appliance must be insta

4For the UserDescriptionof the Appliance Page 5Operation Page 6Maintenanceand Cleaning Page 7Something NotWorking? Page 8ContentsFor the InstallerTech

5Description of the ApplianceINSTALLATIONAny gas installation must be carried out byqualified personnel, and in accordance withexisting rules and regu

6To light a burner, turn the relevant control knobanticlockwise to maximum position and push it downto ignite. Keep the control knob pressed down fora

7Before any maintenance or cleaning can becarried out, you must DISCONNECT theappliance from the electricity supply.The hob is best cleaned whilst it

8Something Not Working?If the appliance is not working correctly, please carry out the following checks before contacting your localService Centre.

9OVERALL DIMENSIONSWidth: 580 mm.Depth: 510 mm.Height: 88 mm.Weight: 9,8 Kg.Instructions for the InstallerCUT OUT DIMENSIONSWidth: 550 mm.Depth: 470 m

10A) End of shaft with nutB) WasherC) Adjustable jointInstallationIMPORTANTThis appliance must be installed by qualifiedpersonnel.The manufacturer wil