Zanussi ZGG642CN Uživatelský manuál

GAS HOBZGG 642INSTRUCTION BOOKLETPlease read this instruction booklet before using the applianceGB

10Building InDimensions are given in mm.Building over a cupboard ordrawerIf the hob is to be installed above a cupboard or drawerit will be necessary

11)Electrical connectionsAny electrical work required to install this hobshould be carried out by a qualified electrician orcompetent person, in accor

12A. IGNITOR SWITCHB. IGNITOR UNITBLN0123456220/240AWiring DiagramFault FindingPreliminary Electrical SystemsCheckA. EARTH CONTINUITY CHECK - Applianc

13Ignition System / Gas IgnitionYESCheck plug top fuseand replace ifnecessaryCheck polarity andearth continuity ofsupply pointCheck earth continuityof

14CommissioningWhen the hob has been fully installed it will be necessaryto check the minimum flame setting. To do this, followthe procedure below.- T

15Guarantee/Customer ServiceStandard guarantee conditionsWe, Zanussi-Electrolux, undertake that if within 12 months of the date of the purchase this Z

16This appliance is guaranteed by Electrolux in each of the countries listed at the back of this user manual, for the periodspecified in the appliance

17

18

19

2Important Safety InformationYou MUST read these warnings carefully before installing or using the hob. If you needassistance, contact our Customer Ca

35690-0402 11/06Grafiche MDM - Forlìwww.zanussi-electrolux.co.uk

3ContentsKeep this instruction book for future referenceand ensure it is passed on to any new owner.For the UserImportant Safety Information 2Descript

4Description of the Hob1. Semi-rapid Burners2. Rapid Burner3. Auxiliary Burner4. Control knobs21314

5OperationHob burnersTo light a burner:z push in the relevant control and turn it to maximumposition;z then adjust the flame as required.z If the burn

6Something Not Working?If the hob is not working correctly, please carry out the following checks before contacting your local Service ForceCentre.IMP

7OVERALL DIMENSIONSWidth: 580 mm.Depth: 510 mm.CUT OUT DIMENSIONSWidth: 550 mm.Depth: 470 mm.SUPPLY CONNECTIONSGas:RC 1/2 inch (1/2 inch male) Rear ri

8Important safety requirementsThis hob must be installed in accordance with the GasSafety (Installation and Use) Regulations (CurrentEdition) and the

9A)End of shaft with nutB) WasherC) ElbowFO 0814FO 0264InstallationIMPORTANTThis hob must be installed by a competent andqualified person only.The man